Hornby R7377 HM7070 Power Bank
New & Improved!
The HM7070 Power Bank has now been made smaller to fit into even more locomotives, whilst still providing an ample amount of stay-alive energy for optimal control.
New size: 1.3cm (w) x 0.7cm (d) x 1.2cm (h). 15cm (l) cable.
The HM7070 Power Bank will keep locomotives running over any potential dead spots. It works in a similar way to 'stay-alive' or capacitors which are available from other manufacturers.
The HM7070 Power Bank can be connected into the current range of HM7000 DCC Bluetooth decoders. A simple plug & play socket means there's no soldering required!
Why use one?
Your layout will occasionally suffer from dirty track or small electrical dead spots at points and crossings. The small loss of power can cause locomotives to stop, but with DCC Sound Decoders it can also cause the sounds to reset and restart. Avoid both issues with the HM7070 Power Bank - you'll have a few seconds of saved power to keep your locomotives going over that dead spot.
Perfect locomotive running and optimal control!
(The Power Bank is not suitable for use without an HM7000 decoder, connecting it directly to other decoders or directly to the wiring of a model locomotive may cause damage to the Power Bank, your locomotive or your non-HM7000 decoder).
Hornby R7142 TTS Sound Decoder - Class P2
The TTS Sound Decoder - Class P2 supports both long and short decoder addresses and features adjustable acceleration and deceleration options as well as 2 sound channels for allowing the play of full locomotive sounds such as bells, wagon couplings and brakes.When operated via F0 on the controller, this decoder has the ability to support directional rear and front lighting - dependent on if the locomotive has lighting features.Motor current: maximum continuous- 500mA; Motor current: peak- 1.amp (no function load); Function output current maximum- 100mA (unprocessed).
Specification
- Item Scale: 1:76 Scale
- Gauge: OO
- Finish: Painted
- Colour: Multi
NCE DCC 0207 Cab Bus Fascia Panel UTP
This is NCEs lowest cost, easiest to use cab bus panel. All four RJ-12 jacks are wired in parallel for easy plug and play use. This board also provides a convenient point to add additional 12 Volt cab bus power, just plug in a 12 Volt "wall wart" power supply. Shown with the included 1/16" thick aluminium, black anodized fascia plate.
