Category Product Lists

High quality superfine-grained green putty offering high adhesion, hard finish and no shrinkage when drying.

One component, water-based, polyurethane product.

Non-flammable, does not contain organic solvents.

Apply on a clean, dry and grease-free surface using a spatula or other tool and let it dry.

It can be cleaned up with water.

Volume: 20ml.

Mr. White Putty R is a lacquer putty that is ideal for filling small gaps, sink marks, pinholes, etc.
It has a lower viscosity than Mr. White Putty, so it can be used in finer areas. It is recommended to apply it using a glue stick or Mr. Glue Applicator. After hardening, it has a smooth cutting property similar to that of plastic model materials.

GREENPOWER is an epoxy putty that when mixed both components at room temperature allows to recreate any model’s piece. Once mixed both components the result becomes a sticky green putty. Then you have about 90 minutes to mold and detail, reaching maximum hardness after 24 hours.

To obtain smoother surfaces it is recommended to use a lubricant such as water, oil, or vaseline, in order to prevent unwanted settling of the putty. The tools must be always lubricated or moistened, and talcum powder can be used to avoid fingerprints, or to add texture. Altering the proportions of both components produces a greater or lesser hardness and hardening faster or slower. Storing the putty in a cool area or even in the refrigerator will keep it in better condition and will last longer.

This product contains 2 stripes of 10cm of putty.

Mr. Melt Putty is a liquid lacquer putty that is ideal for filling large scratches, dents, and sink marks on the surface of parts.

It has a higher viscosity than Mr. Surfacer 500 and has good buildability, so it is suitable for applying in piles. Use a Yoji or Mr. Glue Applicator to apply it. It can
also be used to recreate a cast surface by tapping it onto the surface of the part using a Mr. Weathering Brush.

• Use this handy solution to apply decals which have been left too long in water and lost their adhesion. Simply apply to the surface of the model, and use water to remove any excess adhesive. Features handy brush on reverse side of cap for application. 10ml bottle.